U-Line 2175WCOL manual Initial Startup, Interior Lighting, Electronic Control Panel, Operation

Page 7

5 Operation

ULIN_0080_A

Figure 2

IMPORTANT

Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected.

Initial Startup

All U-Line units are shipped with controls that are preset. No initial adjustments are required.

IMPORTANT

U-Line recommends the unit be allowed to run overnight prior to loading with product.

1

2

3

4

5

ULIN_0184_A

Figure 3

To turn the unit on or off, touch and hold the POWER icon (Figure 3, 1) on the display panel for approximately five seconds until the °F symbol flashes and release.

A small LED above the icon will illuminate to confirm the touch of any controller icon.

The display (Figure 3, 3) will show the unit set-point temperature when the unit is on and will show OFF when the unit is off.

Turning the unit off will override any other control function.

Interior Lighting

The interior of the cabinet can be illuminated whenever the door is opened (default mode), illuminated for a four- hour period, or remained darkened (blackout/Sabbath mode [not Star K certified]).

The LIGHT icon (Figure 3, 5) on the control panel is used to change the lighting functions.

To turn the lights and display OFF (blackout/Sabbath mode [not Star K certified]):

1.Touch and hold the LIGHT icon (Figure 3, 5) for ten seconds and release (the °F symbol will flash briefly at the end of the five second period).

2.The interior light and control display (Figure 3, 3) will go dark for the next 36 hours.

NOTE: Although the display will not be visible, the temperature controls in the unit remain active, and the interior temperature will be maintained.

3.To exit the blackout/Sabbath mode (not Star K certified) before the 36-hour period, repeat Step 1.

To illuminate the interior of the cabinet for a four-hour period:

1.Touch and release the LIGHT icon (Figure 3, 5) to switch from door-operated lighting control to continuous lighting (the °F symbol will flash briefly after the LIGHT icon is pressed).

2.To return to door-operated lighting control before the four-hour period is up, repeat Step 1.

Electronic Control Panel

Your Wine Captain has been designed to provide three temperature zones within the cabinet so the specific storage requirements of your finest wines can be satisfied. NOTE: These are product temperatures, not air temperatures.

1

2

3

4

5

ULIN_0184_A

Figure 4

2115WC and 2115WCOL, 2175WC and 2175WCOL

7

Image 7
Contents 2115WC2175WC Use and Care GuidePlease Record Your Model Information Warranty RegistrationIntroduction Table of Contents Page General Precautions Safety Alert DefinitionsSafety Precautions Échelon Wine Captain Product FeaturesRight Temperature for Wine Superior Features of ÉchelonOperation Initial StartupInterior Lighting Electronic Control PanelAdjusting Temperature Temperature Display SelectionTemperature Display Checking Product TemperatureWine Stocking Recommendations Normal Operating SoundsWine Guide Storage, Vacation, MovingProduct Disposal Wine RecommendationsCommon Food and Wine Matches Suggestions for Matching Food and WineWhite Wines Guide to Common Styles of WineCommon Tasting Terms Red WinesMaintenance General CleaningCleaning and Maintenance Interval Every Three Months Condenser Cleaning175 mm Door Alignment Check and AdjustmentDoor Reversal Light Bulb Replacement Staining and final finish application Wine Rack Removal/InstallationWood Trim Finishing Do not remove the track side rails from the cabinetService Before Calling for ServiceIf Service is Required Replacement PartsTroubleshooting What to check when problems occur Troubleshooting GuideAll Models Task Touch Display Comment Electronic Control Quick GuidePage Line Corporation Limited Warranty For General Inquiries For Service and Parts Assistance
Related manuals
Manual 180 pages 38.87 Kb