U-Line 2175WCOL2 If Service is Required, Initial Startup, Interior Lighting, Replacement Parts

If Service is Required

If you do not understand a troubleshooting remedy, or your product needs service, contact U-Line Corporation directly. Contact information appears on the rear cover of this guide.

You will be asked for your product Model and Serial Numbers. This information should be recorded inside the front cover of this guide, following the products original purchase. It also appears on the Model and Serial number plate located on the upper right or rear wall of the interior of your product.

5 Replacement Parts

When you need replacement parts, always request that genuine U-Line replacements be used. U-Line products have been designed and engineered using components that work efficiently, and provide superior service life and performance. The use of aftermarket parts or components may affect the safety, operation, performance or durability of your product, and may also void its warranty.

6 Operation

ULIN_0080_A

Figure 2

IMPORTANT

Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected.

Initial Startup

All U-Line units are shipped with controls that are preset. No initial adjustments are required.

IMPORTANT

U-Line recommends the unit be allowed to run overnight prior to loading with product.

1 2 3 4 5

ULIN_0184_A

Figure 3

To turn the unit on or off, touch and hold the POWER icon (Figure 3, 1) on the display panel for approximately five seconds until the °F symbol flashes and release.

•A small LED above the icon will illuminate to confirm the touch of any controller icon.

•The display (Figure 3, 3) will show the unit set-point temperature when the unit is on and will show OFF when the unit is off.

•Turning the unit off will override any other control function.

Interior Lighting

The interior of the cabinet can be illuminated whenever the door is opened (default mode), illuminated for a four- hour period, or remained darkened (blackout model).

The LIGHT icon (Figure 3, 5) on the control panel is used to change the lighting functions.

To turn the lights and display OFF (blackout mode):

1.Touch and hold the LIGHT icon (Figure 3, 5) for ten seconds and release (the °F symbol will flash briefly at the end of the five second period).

2.The interior light and control display (Figure 3, 3) will go dark.

NOTE: Although the display will not be visible, the temperature controls in the unit remain active, and the interior temperature will be maintained.

3.To exit the blackout mode before the 36-hour period, repeat Step 1.

To illuminate the interior of the cabinet for a four-hour period:

1.Touch and release the LIGHT icon (Figure 3, 5) to switch from door-operated lighting control to continuous lighting (the °F symbol will flash briefly after the LIGHT icon is pressed).

2.To return to door-operated lighting control before the four-hour period is up, repeat Step 1.

6 2115WC and 2115WCOL2, 2175WC and 2175WCOL2