Ice Maker Maintenance

CAUTION

DO NOT use any type of cleaner on the condenser unit.

4.Clean the condenser coil (Figure 11, 2) using a soft brush with a “combing” action or vacuum cleaner. Do not touch the condenser coil.

5.Position the grille to align the mounting screws with the holes in the cabinet.

6.Secure, but do not over-tighten both grille screws.

7.Reconnect power to the unit.

Inlet Screen

Interval - Every Twelve Months

The solenoid valve inlet screen must be cleaned at least once each year as follows:

1.Shut off the water at the main supply valve.

2.Pull the unit out to access the back panel.

3.Disconnect electrical power to the unit.

ULIN_0054_A

Figure 12

4.Disconnect the hose connector (Figure 12, 1) from the water solenoid valve (Figure 12, 2).

5.DO NOT remove the inlet screen from the water solenoid valve. Use a tooth brush to gently clean any sediment from the inlet screen.

6.Re-connect the water supply hose connector (Figure 12, 1) to the water solenoid valve (Figure 12, 2). Tighten the connector securely.

7.Open the water main supply valve and check for leakage at the water hose connection. Ensure that the water supply line is not kinked.

8.Reconnect power to the unit before re-installing.

Ice Cube Thickness Adjustment

Interval - As Required

On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into the ice maker assembly as follows:

ULIN_0259_A

Figure 13

1. Remove the ice maker assembly cover (Figure 13).

ULIN_0056_A

Figure 14

2.Locate the adjusting screw on the ice maker assembly control box. The adjusting screw is just below the minus (-) and plus (+) signs on the control box (Figure 14).

NOTE: Make adjustments in small increments. Too large of an adjustment could cause the unit to malfunction.

CAUTION

Too large of an adjustment to the screw can cause the water to overflow the ice maker and can cause property damage.

3.Turn the adjusting screw toward the minus (-) sign (clockwise) for smaller cubes or toward the plus (+) sign (counterclockwise) for larger cubes.

4.Install the ice maker assembly cover.

IMPORTANT

Use only genuine U-Line replacement parts. U-Line ice maker parts are not the same as standard FSP Whirlpool parts. Using non U-Line parts can reduce ice rate, cause water to overflow from ice maker mold, damage the unit, and may void the warranty.

CO2175DWR