U-Line CO2175DWR manual Storage, Vacation, Moving, Product Disposal

Page 11

Storage, Vacation, Moving

If the unit will not be used for an extended period, or otherwise stored, follow these steps completely:

WARNING

Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels. Failure to do so may result in death or electrical shock.

1.Remove all consumable contents from the unit.

2.Shut off water supply to the unit at the main water source.

IMPORTANT

If the ambient temperature is expected to drop below 45°F, turn off and unplug unit, and drain all water from the unit to prevent freezing damage not covered by the warranty.

The use of anti-freeze or other products of this nature is not necessary and is not recommended.

3.Disconnect the water valve inlet and outlet lines, and allow them to drain completely.

4.Reconnect power to the unit, and allow it to run for one hour (minimum) until any remaining ice has been ejected from the ice maker assembly.

5.Disconnect power to the unit, dry any remaining water from the ice maker assembly, and reconnect any lines removed from the water supply valve.

6.Disconnect the power cord from its outlet, and leave it disconnected until the unit is returned to service.

7.Clean and dry the interior of the cabinet (See CLEANING AND MAINTENANCE: GENERAL CLEANING).

8.During periods of non-use, the cabinet must remain open to prevent the formation of mold and mildew. Open door a minimum of 2" (5 cm) to provide the necessary ventilation.

Product Disposal

If the unit is being removed from service for disposal, check and obey all Federal, State and/or Local regulations regarding the disposal and recycling of refrigeration appliances, and follow these steps completely:

1.Remove all consumable contents from the unit.

2.Disconnect power to the unit and unplug the power cord from its outlet.

3.Shut off water supply to the unit at the main water source and disconnect the supply line to the unit’s water valve.

DANGER

RISK OF CHILD ENTRAPEMENT. Before you throw away your old refrigerator or freezer, remove the drawers.

4.Remove the drawers from the unit, and secure all shelving and accessories to the interior of the unit using a heavy duty cloth or package sealing tape.

CO2175DWR

11

Image 11
Contents Use and Care Guide Introduction Warranty RegistrationPlease Record Your Model Information Table of Contents This page intentionally left blank Safety Precautions Safety Alert DefinitionsGeneral Precautions Features of Échelon Product FeaturesElectronic Control Panel Temperature Display SelectionInitial Start-up Interior LightingIce Maker Temperature DisplayAdjusting Temperature Normal Operating Sounds Drawer Organizer Food StorageDrawers Top Storage BinProduct Disposal Storage, Vacation, MovingCleaning and Maintenance General CleaningMaintenance Do not use any type of cleaner on the condenser unit Ice Maker MaintenanceLeveling Light Bulb ReplacementService Before Calling for ServiceIf Service is Required Replacement PartsElectrocution Hazard Troubleshooting GuideICE Cube Thickness Adjustment All Models Task Touch Display Comment Electronic Control Quick GuideLine Corporation Limited Warranty For General Inquiries For Service and Parts Assistance