U-Line CO2175DWR manual Ice Maker, Temperature Display, Adjusting Temperature

Temperature Display

To display the interior temperature:

1.Touch and hold the WARMER icon (Figure 4, 2) for approximately five seconds and release when the °F symbol in the display (Figure 4, 3) begins to flash.

2.The display (Figure 4, 3) will indicate the actual refrigerator temperature.

3.After approximately 10 seconds, the set-point temperature will return to the display.

Factors which affect the internal temperatures of the cabinet include:

•Temperature setting.

•Ambient temperature where installed.

•Number of times and length of time the door is opened and closed.

•Installation in direct sunlight or near a heat source.

Adjusting Temperature

NOTE: The top drawer refrigerator section temperature is adjustable. The bottom drawer freezer temperature is not adjustable.

IMPORTANT

Adjust the set-point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking.

1 2 3 4 5

ULIN_0058_A

Figure 5

To adjust the set-point temperature:

1.Press and release either the WARMER (Figure 5, 2) or COOLER (Figure 5, 4) icon to put the controller in the SET TEMPERATURE mode. The °F symbol (Figure 5, 3) will begin to flash.

NOTE: If no further action is taken, this mode will self cancel in five seconds, and the original set-point temperature will be displayed.

2.While the °F symbol is flashing, press the WARMER or COOLER icon as required to adjust the set-point temperature.

3.The change will be set five seconds after adjusting the temperature and the new set-point temperature will be displayed.

Ice Maker

When the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to cool and maintain the cube supply. Frost-free icemaker units have lower ice production than manual defrost units.

ULIN_0087_A

Figure 6

Ice production may be interrupted by raising the bin arm into an upright and locked position (Figure 6). The unit will maintain temperature for ice storage.

IMPORTANT

If you are not intending to use the ice maker and turn the supply valve off, it is imperative to raise the bin arm of the ice maker (Figure 6). Failure to raise the bin arm may result in damage to the water valve.

Certain sounds are normal during the unit’s operation. You may hear the compressor or fan motor, the water valve, or ice dropping into the ice bucket.

WARNING

NEVER use an ice pick, knife, or other sharp instrument to separate cubes. Shake the ice bucket instead.

During periods of limited usage or high ambient temperatures, it is common for cubes to fuse together. Shake the bucket to break apart cubes. If the ice maker is not used regularly, the ice bucket should be emptied periodically to ensure fresh cubes.

8 CO2175DWR