Ayre Acoustics P-5XE owner manual Tonearms with a Mini-DIN Connector

Page 14

turntable, the custom cables must be made flexible to allow proper motion of the suspended sub-chassis. This is normally done by removing a section of the cable’s outer jacket near the turntable.

A custom phono cable using a single cable may also be used as shown below:

To

Turntable

Male RCA

Shield

Male XLR

1

To Phono

Preamplifier

1

Spade Lug

Ground Wire

Spade Lug

Please note that this configuration requires cabling that has a multiple of four conductors plus a shield. If there are eight or twelve conductors, they must be paralleled to create four composite conductors. Also, a short section of the cable jacket must be removed at each end of the custom cable to allow the connectors to be physically separated.

Tonearms with a Mini-DIN Connector

Another common tonearm configuration has a 5-pin mini-DIN connector below the turntable base. This

12

Page 13 Page 15
Image 14
Page 13 Page 15
Contents MC/MM Phono Preamplifier Page Contents Ayre Inputs InstallationLocation R e AC Power OutputsSetting the Gain OperationSetting Setting the Loading Break-In Customization Custom Loading ResistorsCustom Phono Cables Turntables with RCA Connectors Tonearms with a Mini-DIN Connector Page Female DIN Shield Specifications Warranty North American WarrantyNorth American Warranty Statement International Warranty Place for Revision Page Ayre Acoustics, Inc Central Avenue Boulder, Colorado
Top Page Image Contents