CLEANING AND MAINTAINENCE
After each use and before cleaning, allow the unit to stop and unplug the appli-
ance from outlet. DO NOT ATTEMPT TO CLEAN WHILE THE
MOTOR IS RUNNING OR THE COMPONENTS ARE STILL MOV- ING. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN SERIOUS INJURY OR ELECTRICAL SHOCK.
•CAUTION: NEVER IMMERSE THE BASE UNIT,CORD OR PLUG IN WATER OR OTHER LIQUIDS.
•Toclean the base, rotary control knob and cord, wipe clean with a damp sponge or cloth and dry immediately. Never use excess water, treated cloths, harsh cleaning agents, or sprays.
•Remove blender jar, dispenser, dispenser lever,drip tray,lid and filler cap. It is recommended to wash the components immediately after each use in warm, soapy water. Rinse and dry thoroughly. Jar blades are extremely sharp. Wash blades carefully and avoid direct contact with the blades themselves.
•Toremove the dispenser lever,please follow the steps below:
1.Pull up shield.
2.Press against dispenser lever as shown.
3.Lift up the dispenser lever.
4.Move the dispenser lever forward and out.
1
2 | 3 | 4 |
DO NOT FORCIBLY PULL ON THE DISPENSER LEVER, AS DAMAGEWILL RESULT.
9