In order for this dishwasher to work, the following are required:
. | • COLD WATER SUPPLY |
. | • DRAINAGE FOR USED WATER |
. | • ELECTRICITY: 115 VOLT, 60Hz Outlet |
. | • GROUNDING |
. | • HORIZONTAL FLAT SURFACE |
Note: For your convenience, the water inlet hose and drain hose are preinstalled to the dishwasher from the factory. Both hoses are located behind the dishwasher at the left bottom of the dishwasher.
1.1. You dishwasher must be placed on horizontal flat surface near by the sink on the kitchen bench (countertop). Placing the dishwasher as near to a sink as possible to allow for proper installation of the water inlet and drainage hoses.
2.2. Connect the other end of water inlet hose to the cold water faucet.
(Quick Connect Sink Adapter is supplied)
1.3. The other end of the drain hose must be placed properly in the sink or at yourdrain outlet in order to let used water drained out from the dishwasher.
2.4. Plug in the dishwasher to a regular 115 Volt / 60 Hz, 15 Amp. Outlet.
Drain Hose
Note: This figure is for illustration purpose only.
Note: Inspect carefully for any water leak around and back of the machine. If any leak occurs, double check to see if any connections are loose. You may need to tighten any loose connections.
| Understanding the Drain Hose Hook Up: |
. | • Your dishwasher is equipped with a gravity drain system. The drain hose should be positioned |
above the drain in order to drain properly. | |
. | • If the drain hose is bent or shrunken, it may affect water draining. |
. | • If water cannot be drained out smoothly, the dishwasher operation will be disturbed and it may |
stop in the middle of the cycle.
18