Smeg SA9066CER manual Extraordinary Maintenance, Replacement of light bulb, Removing the door

Page 14

Instructions for the user

12.EXTRAORDINARY MAINTENANCE

The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations.

Before any intervention, disconnect the power supply of the device.

12.1 Replacement of light bulb

Remove cover A by twisting anticlockwise, replace bulb B with another similar bulb (25 W). Refit the cover A.

Only use oven bulbs (T 300°C).

12.2 Removing the door

Hold the door on both sides with both hands near hinges A and raise levers B. Lift up the door forming an angle of about 45° and remove. To refit, slide the hinges A in the grooves, drop the door and release levers B.

12.3 Oven door seal

To permit thorough cleaning of the oven, the seal may be removed. Before removing the seal, take off the door as described above. Once the door has been taken off, lift the tabs at the corners as shown in the figure.

16

Image 14
Contents Contents Plate Must not be Removed Instructions for Proper USEDisposal Instructions OUR Environment Policy Safety Precaution WAY of ChildrenBefore First USE Intended USE of the ApplianceKnow Your Cooker USE of the HOB Cooking zoneOven Thermostat Knob Front Control PanelCooking HOB Control Knob Oven Control Knob Thermostat Indicator Light OrangeVariable Grill Indicator Light RED Cooling system How to use the grillUSE of the Oven Use of the electric grillStorage compartment Semiautomatic cooking Clock adjustmentElectronic Programmer Automatic cookingCancellation of set data Adjusting alarm volumeSwitching off the alarm Minute CounterOrdinary daily cleaning Cleaning and MaintenanceCleaning stainless steel Cleaning the glazed ceramic hobCleaning of oven Door glassRemoving the door Extraordinary MaintenanceReplacement of light bulb Oven door sealInstallation of the Appliance Electrical connectionWall fixing where applicable Mounting the rear top skirtboard where applicable