Instructions for the Installer
5.Adapting to different types of gas
The operations described below must be carried out with the appliance not connected to the gas supply.
The appliance is tested with G20 (2H) natural gas at the pressure of 20 mbar.
If it is to be used with other types of gas, the burner nozzles have to be changed and the primary air flow adjusted.
To replace the nozzles and adjust the burners, the hob skin has to be removed. Proceed as described below.
5.1 Removing the hob skin
Remove all the burner components in the numerical order shown below:
• Pull off all the knobs.
• Lift all the burner components off the hob.
1
•Remove the hob skin
fixing screws.
2
•After removing all the
components described above, lift off the hob skin. Release all snap connections simultaneously (the hob is connected to the casing underneath in 5 points).
3
During reassembly, after putting the hob skin in position, press down on the points shown above to snap all the connections back into place.
25