Smeg SBC30 manual Transformations, Transformation of the Input Type

Page 10

TRANSFORMATIONS

Before any kind of transformation is necessary to cut off the electricity.

6)TRANSFORMATION OF THE INPUT TYPE

The standard equipment of the appliances is for single phase connection. In any case, under proper changes, they can be fed with a three phase system.

To obtain these changes, please, follow the instructions:

a)Take off the panel stuck by screws "V" (see fig. 14).

b)Remove the connection jumpers on the clamp following the scheme of fig.15 of page (attached on the body).

c)Insert the input cable with adequate section (see scheme paragraph 5) into the chock.

d)Connect the phase cable into the clamp and the "earth" cable in the relative clamp.

e)Hold up the input cable with the pertinent stopcable.

f)Replace the panel in its seat and hold up with the pertinent screws "V" (see fig. 14).

FIG. 14

FIG. 15

26

Image 10
Contents Tipo Pfvz MOD. SBC30 Description of the HOT Plates Type PfvzUSE Electric HOBScheme RegulatorsUSE Cleaning Installation InsertingFixing Electrical Connection Transformations Transformation of the Input TypePower of Electrical Components MaintenanceTechnical Characteristics of the Electricalcomponents Components SubstitutionTechnical Data Voltage 230 240 V ~ Frequency 50/60 Hz Tot. Rating 5900 WVoltage 230 240 V ~ Frequency 50/60 Hz Tot. Rating 2200 W Technical Assistance and Spare Parts