Smeg ST93P manual Installation instructions, Installation and hook-up

Page 6

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. Make sure to tighten the locking ring-nut once the pipes have been placed in the direction required. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher.

Building-in a dishwasher underneath a ceramic hob is absolutely forbidden.

A dishwasher can be built-in underneath a conventional hob provided there is no break in the kitchen worktop, and the dishwasher and hob are installed and secured correctly, so that no hazards are generated.

The fully integrated models are equipped with only one adjustable foot at the rear, which can be adjusted by turning the screw on the lower front part of the appliance.

7

Image 6
Contents Dishwasher Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation instructions Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance For Great Britain onlyDescription of the controls Upper panelSetting the Washing Program and Switching on User instructionsPrewash at 45C Table for Certification Bodies Normal ECOUser instructions Cancelling the Current Program Washing programsChanging the Program Selecting Half Load Wash Extra ProgramsDelaying the Program To Save on ENERGY! … and Protect the EnvironmentEND of Cycle Removing the DishesUsing the rinse aid and detergent dispensers Operating instructionsAdding the Rinse AID Adjusting the Rinse AID Dispenser Setting Adding the DetergentUser instructions General warnings and recommendations User instructions Using the baskets Lower BasketLoading the Lower Basket Cutlery BasketUpper Basket Loading the Upper Basket Adjusting the Upper Basket Version aCleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Cleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Troubleshooting Fault DescriptionTechnical Data 598