Smeg KSEG5, KSEG7 manual Safety USE, Maintenance, Metal grease filters

Page 6

WARNINGS - USE - MAINTENANCE

4-SAFETY USE

It is most important that all the warnings shown in paragraph 2 of the Installation Instructions are strictly observed.

Moreover, special attention must be paid to the following warnings during the use and mainte- nance of the cooker hood:

4.1- The grease filters and the charcoal filters should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently (more than 4 hours per day).

4.2- When using a gas hob in connection with the cooker hood never leave the burners of the hob uncovered while the hood is in use or when the pans have been removed. Switch off the gas be- fore removing the pan or for just short periods and never leave the hob unattended.

4.3- Always ensure that the appliance is kept at the correct intensity to prevent the flame from licking round from the bottom of the pan; this will save energy and will avoid a dangerous concentration of heat.

4.4- Always ensure that the appliance is used in accordance with the manufacturer’s instructions for the removal of contaminated odours during cooking.

5- USE (fig.5)

BUTTON

LED

FUNCTIONS

T1

Speed

On

Turns the Motor on at Speed one.

 

 

 

Turns the Motor off.

T2

Speed

On

Turns the Motor on at Speed two.

T3

Speed

Fixed

When pressed briefly, turns the Motor on at Speed three.

L

Light

 

Turns the Lighting System on and off.

Warning: Button T1 turns the motor off, after first passing to speed one.

6 - MAINTENANCE

Regular maintenance and cleaning will ensure good performance and reliability, while extend- ing the working life of the hood. Special attentions should be paid to the grease filters and to the charcoal filters when the hood is used in the recirculation mode.

6.1- Metal grease filters

1 - Cleaning

The metal grease filter should be cleaned every two months with normal usage and can be cleaned in a dishwasher or by hand using mild detergent or liquid soap.

2 - Replacement

The metal filters are easily removed, one at a time, applying a slight pressure towards the rear of the hood while pulling downwards (fig. 6).

EN

 

6

 

6

Image 6
Contents KSEG5 KSEG7 Index Innehåll Safety Warnings General InformationDucting or recirculation fitting InstallationInstallation of the fitted group Electrical connection and working testSafety USE MaintenanceMetal grease filters Grease Filters metal panels CleaningSynthetic filters Charcoal filtersPage Page Page 436004767ver1