Smeg KSE912NX manual Lighting, Substitution of the Charcoal Filter, Light Replacement

Charcoal filter (recycling version)

This filter cannot be washed or regenerated. It has to be replaced when the EF appears on the display or at least once every 4 months.

Activation of the alarm signal

•In the recycling version hoods the filter saturation alarm has to be activated during the in- stallation or later.

•Switch off the hood and the lights.

•Press the E-key for about 5 seconds until the LED on the display start to move.

•Press the B-key within 5 seconds until a confirmation of the activated state of filter satura- tion alarm on the display appears:

•2 flashings on EF - charcoal filter saturation alarm ACTIVATED

•1 flashing on EF - charcoal filter saturation alarm DEACTIVATED.

SUBSTITUTION OF THE CHARCOAL FILTER

Alarm reset

•Switch off the motor and the lighting system.

•Press the G-key for at least 2 seconds.

Substitution of the filter

•Remove the metal grease filters.

•Remove the charcoal filter as indicated in the picture.

•Place the filter again into its seat.

•Place again the metal grease filters into their place.

Lighting

LIGHT REPLACEMENT

20 W halogen light.

• Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood.

• Extract the lamp from the Support.

•Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes.

•Refit the Support, fixing it in place with the two screws re- moved as above.

EN	2
	27