User Instructions
12 EXTRAORDINARY MAINTENANCE
The oven periodically requires minor maintenance or replacement of wearing parts such as seals, bulbs, etc. See below for specific instructions on how to carry out this type of maintenance.
Before carrying out any such procedure, you must disconnect the electricity supply to the appliance.
12.1 Lubricating the taps and gas oven thermostat
Over time, the taps and the gas oven thermostat may encounter rotation problems and get stuck. They should be cleaned internally and the lubrication grease should be replaced. This must be carried out by a specialised technician.
12.2 Replacing the bulb
Remove the bulb protector A by twisting it from left to right; replace bulb B with another equivalent bulb (25 W). Remount the bulb protector A.
Only use special oven bulbs (T 300°C).
12.3 Demounting the door
Take hold of the door with both hands on each side, near the hinges A, and lift the levers B. Raise the door at a 45° angle and remove it. To remount the door, fit hinges A into the grooves; allow the door to be supported towards the base and position the levers B.
12.4 Oven door seal
To enable the oven to be thoroughly cleaned, the door seal can be removed. Before removing the seal, the oven door must be demounted as described above. Once the door has been demounted, lift the tabs at the corners of the seal, as shown in the figure on the right.
24