Smeg LVF32G User instructions Operating instructions, Using the water softening system

Page 12

User instructions

4. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

4.1 Using the water softening system

The amount of scale contained in the water (water hardness

 

index) can cause whitish staining on the dry dishes, which

 

tend to become dull over time. The dishwasher is equipped

 

with an automatic softening system which uses a special

 

regenerating salt to reduce the hardness of the water.

 

The dishwasher is factory set for water hardness level 3

SALT

(average hardness 41-60°dF24-31°dH).

 

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg of salt in grains. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.

Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system.

When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion.

Be careful not to confuse the salt and detergent packages; adding detergent to the salt container will damage the water softening system.

34

Image 12
Contents Dishwasher Italiano English Contents Safety instructions Safety and operating instructionsAquastop Models Installation instructions Installation and hook-up Connecting to the Water SupplyWater supply connection Installation instructions Electrical connectionDrain Connection User instructions Description of the controls Front panelSetting the Washing Program User instructionsTable of Programs Half Load Wash Setting Cancelling the Current ProgramWashing programs Table for Certification BodiesProgram Delay Changing the ProgramEND of Cycle Removing the DishesUsing the water softening system User instructions Operating instructionsAdjusting the Water Softening System Water Hardness Table SettingUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser SettingAdding the Rinse AID Adding the Detergent General warnings and recommendations Using the baskets Lower BasketLoading the Lower Basket Cutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketUser instructions Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Cleaning the Orbital Version Spray ARMCleaning the Filter Unit Prolonged DisuseTroubleshooting Minor Problems Technical Data Page