SPEAKER CONNECTIONS
MODELS: L810, L820
Receiver’s Speaker Outputs
MODEL: LC2
– 
+
–+
Receiver’s Speaker Outputs
Speakers and electronics have corresponding (+) and (–) terminals. It is important to connect both speakers identi- cally: (+) on the speaker to (+) on the amplifier and (–) on the speaker to (–) on the amplifier. Wiring “out of phase” results in thin sound, weak bass and poor imaging.
To use the binding-post speaker terminals, unscrew the colored collar until the pass-through hole in the cen- ter post is visible. Insert the bare end of the wire through this hole; then screw the collar down until the connection
is tight.
The hole in the center of each collar is intended for use with banana-type connectors. To comply with European CE certification, these holes are blocked with plastic inserts at the point of manufacture. To use banana-type connectors requires the removal of the inserts. Do not remove these inserts if you are using the product in an area covered by the European CE certification.
BI-WIRING
The bi-wire connection method requires one amplifier and two sets of speaker wires. By removing the shorting bars, connections may be made to the individual network sections using four conductors, one for each of the four terminals.
For single-wire connection, leave the shorting bars in place and connect only a sin- gle set of speaker wires (two conductors) to the two upper terminals.
High Frequency |
– | + |
– | |
Low Frequency |
–+
Amplifier
Bi-Wire Connections
SPEAKER SETUP
MODELS: L810,
L820, LC2
Place pads here
The supplied self-adhesive rubber feet may be attached to the bottom corners of your speakers to protect your furniture.
