Smeg STX1-7, STX1-5 manual Water loaded accurately. Interrupt the program

User instructions

E7

E8

E9



FAULT	DESCRIPTION
	Turbine flow-regulator malfunction
	(for the relevant models only)
	The appliance is not able to "measure" the amount
	of water loaded accurately. Interrupt the program
	and switch off the dishwasher. Switch the
	dishwasher back on, program it again and start
	the washing cycle. If the problem persists, contact
	the after-sales service.
	Alternate washing system malfunction
	Interrupt the program and switch off the dishwasher.
	Switch the dishwasher back on, program it again and
	start the washing cycle. If the problem persists,
	contact the after-sales service.
	Water intake system malfunction
	Contact the after-sales service.
Light off	Light on	Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.