en | en |
Replacing the interior light
bulb (Fig. 6-7)
Should the light fail to work, proceed as follows. Switch off the circuit breaker or unplug the power cable.
Then ensure the bulb is screwed securely in the bulb holder. Plug in the power and switch on the circuit breaker.
If the light still fails, obtain a replacement E14
Cleaning and care
Interior and Exterior Surfaces
Attention
Always unplug the power cable or switch off the circuit breaker before cleaning.
Clean the exterior using lukewarm water and a mild detergent.
Never use detergents, abrasive or acidic agents.
Wipe the inside compartment dry.
Be careful to prevent water from getting into contact with the electrical connections of the temperature control or the interior light.
If the appliance is not going to be used for a long period of time, unplug the power cable and remove all food. Clean the appliance and keep the door open.
To preserve the appearance of your appliance, you can polish the exterior and the door accessories with a silicone wax.
Clean the condenser at the back of the appliance once a year using a brush or a vacuum cleaner. Dust
Inspect the door gasket at regular intervals.
Clean with water only, and wipe totally dry.
Cleaning of the accessories
Door shelves:
Remove all food from the door shelves.
Lift the cover of the shelf upwards and pull it off sideward.
Remove the bottom of the door shelf by pushing it upwards.
Collecting container (Pan):
Make sure that the pan at the back of the appliance is always clean.
Gently release the snap of the pan from the compressor by pushing it using a tool (like screwdriver), so that the pan can be removed.
Lift the pan, clean it and wipe it dry.
Crisper or Drawers:
To clean a drawer, pull it out as far as possible, tilt it upwards and then pull it out completely.
Odor filter:
The odor filter at the back of your fresh food compartment prevents formation of bad smell in your product .
To clean the odor filter, remove the plastic cover and leave the filter under sun light for a day. Filter will be cleaned during this period. Fit the filter back to its place (Fig. 5). Perform this operation once a year.
8