User instructions
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:
•The filters should be cleaned under running water using a stiff brush.
•When removing the filter, take care that there are no food residues on it. If any residues fall into the washing pit they might block hydraulic components, or foul the spray arm nozzles.
•It is essential to thoroughly clean the filters according to the above instructions: the dishwasher cannot function if the filters are clogged.
•Carefully replace the filters in their seats, to avoid damaging the wash pump.
PROLONGED DISUSE:
•Run the soak program twice in succession.
•Unplug the power cord from the socket.
•Leave the door slightly open, in order to prevent the formation of unpleasant odours inside the washing tank.
•Fill the rinse aid dispenser.
•Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:
•Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes.
•Plug the power cord back into the socket.
•Reconnect the water intake hose and open the tap again.
TROUBLESHOOTING MINOR PROBLEMS
In some cases it is possible to remedy minor problems by referring to the following instructions:
If the program fails to start, check that:
•the dishwasher is connected to the electrical power supply;
•there is no power failure;
•the water tap is open;
•the dishwasher door is properly closed.
If water remains inside the dishwasher, check that:
•the drain hose is not kinked;
•the drain siphon is not obstructed;
•the dishwasher filters are not clogged.
26