Smeg DF41-7 instruction manual Installation and hook-up, Water supply connection

Page 6

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. Make sure to tighten the locking ring-nut once the pipes have been placed in the direction required. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher.

Building-in a dishwasher underneath a ceramic hob is absolutely forbidden.

A dishwasher can be built-in underneath a conventional hob provided there is no break in the kitchen worktop, and the dishwasher and hob are installed and secured correctly, so that no hazards are generated.

When installing the dishwasher in a compartment next to one or more other appliances, it is essential to comply with all the recommendations provided by the appliance’s manufacturer (minimum distances, installation procedures, etc.).

The dishwasher is equipped with only one adjustable foot at the rear, which can be adjusted by turning the screw on the lower front part of the appliance.

ù

2.1 Water supply connection

Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused.

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents
Guide for Using the Dishwasher and the Washing Programs Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up Water supply connectionConnecting to the Water Supply Drain ConnectionElectrical connection and precautions If the Appliance is Provided with a Plugless Supply CordUser instructions For Great Britain onlySetting the Washing Program and Switching on Description of the controlsUpper panel 105 Delaying the Program Washing programsOption Button Cancelling the Current Program Changing the ProgramEND of Cycle Removing the DishesUsing the water softening system Operating instructionsUser instructions Using the rinse aid and detergent dispensers Water Hardness TableAdjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations ProductsUser instructions Using the baskets Lower BasketLoading the Lower Basket Cutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketCleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Cleaning the Spray ARM, Travelling Version Cleaning the Filter UnitGeneral Warnings and Recommendations for Correct Maintenance If the dishes are not being cleaned properly, check that Troubleshooting Fault DescriptionWater loaded accurately. Interrupt the program Technical Data