Instructions for the User
15.4 what to do if...
The oven display is completely off:
•Check the mains power supply.
•Check whether an omnipolar switch upstream from the oven feed line is in the “ON” position.
The oven does not heat up:
•Check whether the “showroom” mode has been set, for further details see point “10.7 Secondary menu”.
The controls do not respond:
•Check whether the “child
The cooking times are longer than those • indicated in the table:
After the automatic “pyrolysis” cleaning cycle •
(only on some models) it is not possible to select a function:
Check whether the “power limiter” mode has been set, for further details see point “10.7 Secondary menu”.
Verify whether the door interlock device has been switched off. If it has not, the oven has a protection device that does not allow functions to be selected while the door interlock device is active.
The display shows ERR 4 (on pyrolytic models only):
•The door interlock device has not hooked up to the door properly. This might be because the door was accidentally opened during its activation. Switch off the oven and switch it on again waiting a few minutes before selecting a new cleaning cycle.
If the door is opened during a
This is not a fault. It is a normal operation of the appliance, useful when cooking foods in order to avoid excessive heat escaping. When the door is closed, the oven will return to normal operation.
If the problem has not been resolved or there are other types of faults, contact your local technical assistance centre.
56