Instructions for the user
5.USE OF THE COOKING HOB
5.1Lighting the burners
Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples.
Panstand grid B, available upon request, is intended for use with woks (Chinese pans).
To prevent damage to the worktop, the hob is equipped with a raised grid C: installs over pans larger than the diameter shown in the table in paragraph " 5.3 Diameter of receptacles". Note that pans larger than 28 cm diameter must be used only on the central burner.
Each knob corresponds to the burner indicated. The appliance is equipped with an electric lighting device. To light the burners, press and turn the knob
anticlockwise to the large flame symbol 
. Keep the knob pressed for about 2 seconds to let the thermocouple heat up.
If the burner turns off when the knob is released, it means that the thermocouple isn’t hot enough. Repeat ignition and keep the knob pressed longer.
Once the burner has been ignited, the flame can be regulated as required.
Always check that the control knobs are in the position
(off) when you finish using the hob.
If the burners turn off accidentally, a safety device will trip after about 20 seconds to cut off gas flow (even with the gas tap open).
24