Smeg SA301X manual Removing, Oven door seal

Page 20

Instructions for the user

8.2 Removing

Raise levers on each hinge A to lock the hinges before attempting to remove the door. Hold the door on both sides with both hands near hinges B. Lift up the door forming an angle of about 45° and remove. To refit, slide the hinges A into slots in oven frame. Locate the grooves (C) over frame of oven in hinge cut out, lower the door and release the locking levers (B).

8.3 Oven door seal

To permit thorough cleaning of the oven, the seal may be removed. Before removing the seal, take off the door as described above. Once the door has been taken off, lift the tabs at the corners as shown in the figure.

After cleaning, refit the seal with the longer side horizontal and insert the tabs into the appropriate holes starting from the top ones.

22

Image 20
Contents Contents Introduction Instructions for Safe and Proper USEPlate Must not be Removed Instructions for the installer InstallationElectrical connection This label must never be removedMounting the oven Instructions for the installer Function Switch Knob Instructions for the userDescription of Controls Front control panelTimer Knob only on Some Models Electronic Analogue Clock on some models onlyThermostat Knob List of FunctionsSetting the time Minute-minderProgramming Instructions for the user Oven light USE of the OvenCooling system Available Accessories Some models do not feature all accessoriesTraditional cooking Function Switch Thermostat SwitchCooking Hints Keep the oven door closed during cooking Hot-air cookingGrill cooking Function Switch Thermostat Switch in Position Hot-air grillingDefrosting 220Cleaning and Maintenance Cleaning stainless steelCleaning of the oven without self-cleaning panels Ordinary Daily CleaningDo not USE a Steam JET for Cleaning the Inside of the Oven Self-cleaning linersUsing the self-cleaning liners Looking after the self-cleaning linersDoor glass Extraordinary MaintenanceReplacement of light bulb Removing Oven door seal