Instructions for the User
Press START to confirm the start of the program.
The program starts, performing the preheating stage; the display shows "PrEh".
When the preheating is complete, a "BEEP" sounds to indicate that cooking can start, and the message "PrEh" flashes on the display.
Keep START pressed for a few seconds to start cooking; another BEEP sounds to signal the switch from preheating to cooking. (If START is not pressed after the beep, the temperature is held constant for about 10 minutes, after which it will start to drop for a period up to a maximum time of 20 minutes, counted from when the beep sounded. After this the oven switches off).
N.B. – although this is not recommended in terms of cooking quality, the program can be started even before the preheating temperature is reached by keeping START pressed for a few seconds.
During cooking, the display shows the time left until the end of the cooking process, the temperature set and the number of the program being used, in alternation. During the last minute of cooking, the display will only show the countdown from 60 to zero seconds (end of cooking time). When all the cooking time has passed, a BEEP and the flashing message "End" will indicate that cooking is over. Once a cooking operation has finished, the user can extend the cooking time exactly as required in manual mode, as follows. Press START; the display will show "tp00". From now on, each pressure on the START key corresponds to one more minute's cooking; up to 10 extra minutes are permitted. Cooking will restart at the programmed temperature after 5 seconds. After these additional minutes, the program repeats the cooking end procedure described above and word "End" will flash for 20 minutes, during which time the temperature will gradually fall, stabilising at 100°C for cooking processes at 100°C or above, or at the program temperature for cooking operations at below 100°C. After 20 minutes, the oven switches off.
N.B. - during preheating and cooking, whenever the door is opened the message "door" will appear on the display and a beep will sound to warn the user that the door must be closed while these operations are in progress.
4.7Modifying a previously edited program
To modify one of the programs, turn the knob to one of the programs from P1 to P14 edited previously.
The parameters saved earlier will appear on the display. Hold down STOP for 2 seconds.
The display shows U t°C.
Press START to display the cooking temperature.
Press START or keep it pressed to increase the cooking temperature; each time START is pressed the temperature increments by 1°C (from 50° to 300°), or hold START down for increments of 5°C.
Press STOP to move on to displaying the next parameter
26