Electrolux Comprehensive Guide for Troubleshooting Washers

Service

Manual 12. Operational sequences

11 9002 1 12

Type Edition Page

Trouble shooting 1

Fault indication

Fig. The microprocessor-controlled machines have an

1automatic trouble shooting program which continuously monitors the main functions. If a fault

Fig. occurs in service, a nummerical code (see table Error code

2below) blinks on the control panel display.

When error code 01 or 02 are displayed, a restart can be done after the fault has been put right.

When the other codes are displayed, the main switch must be turned off and then on again before the machine can be restarted.

Built-in service program

There is a built-in service program which facilitates function controls and fault tracing. With the program, different switches and sensors, such as the door safety lock and coin meter, can be checked. It is also easy to direct and thereby check the machine parts, such as motor, valves and door safety lcok.

2

3

2....

1 ....

1026

Error code Error		Probable remedy/Solution
01	Water level not reached	Is the water shut-off valve open? Push START restart.
02	Door lock in operative	Open and close door again.
		Push START for restart.
03	Shortcircuit	Shortcircuit in temperature sensor or in the cable
	Water temperature over 98° C	between sensor and circuit board.
04
05	Water in machine	Check drain and level sensor system.
	before program start
06	Machine memory fault
07	Machine heats incorrectly	Check heating system and thermostat.
08	Drain time too long	Check drain system.
09	Out-of-balance switch in operative