12 | 13 | 9010 | 16 |
Type | Edition | Page |
| Service |
12. Function Sequences | Manual |
Programmer advance
The timer motor advances in the following way:
From timer
Rows 1a (1) is closed during all drain and spin cycles. They are also closed during the first part of the wash and rinse cycles when water is filling.
From level sensor
When water fills to the correct level, the level sensor's contact changes over and point E in the diagram receives voltage (see section on ''Water filling''). During those cycles when timer row 1a (1) is open, the level sensor controls the advance of the timer motor. As a result, it water dows not fill to the correct level, the timer will stop.
At program rapid advance
Contact K51 (2) closes when the program is rapid advanced so that the motor always receives voltage.
Sequence diagram
1a.Timermotor direct
Prewash | Drain |
|
|
| Mainwash |
|
| Cool | Drain | Rinse 1 | Drain/ | Rinse 2 | Drain/ |
| Rinse 3 |
| Drain | Spin |
|
| Tumbling | Open | Start | ||||||||||||||
|
|
|
|
| down | Spin |
| Spin |
|
|
|
| |||||||||||||||||||||||||
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 10 11 12 13 14 15 16 | 17 18 19 | 20 21 | 22 23 24 | 25 26 | 27 | 28 29 30 | 31 32 33 | 34 35 36 37 38 | 39 40 | 41 42 43 44 45 | 46 47 48 49 50 | 51 | 52 | ||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3'' | (27)'' | 30'' | P1+ 120'' | 30'' | 30'' | 3'' | 27'' | 30'' P1+ 120'' 30'' 30'' 30'' 30'' | 30'' 30'' |
| P2+ 120'' | 30'' 30'' | 3'' 27'' P2+ 30'' | 30'' 30'' | 30'' | 3'' 27'' P2+ 30'' | 30'' 30'' 30'' | 3'' | 27'' 30'' P2+ 30'' | 30'' 30'' 30'' | 30'' 30'' 120'' | 30'' 30'' 3'' | 27'' 30'' 30'' 120'' | Off/Start |
| ||||||||||||
