Levelling

To level the refrigerator use

the two levelling screws found on the base at the front. Make sure that the refrigerator is placed on level ground. Adjust the levelling screws to ensure that the refrigerator doesn’t move during day-to-day use.

Turn the screws anti- clockwise to lift the front of the refrigerator and clockwise to lower it.

The front part of the refrigerator should be a little higher than the back causing it to tilt backwards slightly. Levelling requires two people; one to tilt the unit backwards and the other to turn the screws.

Front
Levelling	Front	Back
screws	wheels	wheels

Front

Front
48mm
Levelling	Front	Back
screws	wheels	wheels

To level it, lift the front by turning the screws until there is a 48 mm (1.9 in) gap between the floor and the base of the refrigerator, as indicated in the figure on the right.

observe the following when installing:

important – after leaving the refrigerator to stand 6 to 8 hours and before plugging it in:

1.Clean the interior of your refrigerator with a cloth or soft sponge, and a neutral soap or a soda bicarbonate solution.

2.Plug it in to the correct outlet.

3.Leave it on, empty and closed, for 4 hours before putting food inside.

4.Avoid opening the door before optimum temperature has been reached.

5.If you want to move your refrigerator to another location, disconnect it. When it has been repositioned repeat steps 3 and 4.

caution

In the case of physical, mental or sensorial difficulties (including children), or if you don’t have sufficient experience or knowledge to handle this product, you will need the assistance of a capable adult to ensure safety.

Children should always be supervised. This product is not a toy.