PACKAGING MATERIAL
Remove all tape that holds lift up glass and doors in place. Some residue will be left and this can be removed with glass cleaner.
Remove all plastic ties that hold shelves and brackets for shelves.
LIGHTS
Make sure lights are in their lamp holders. Also make sure plugs for lamp holders are completely plugged in. If they are loose it may cause lamp holder to burn.
SHELVES
To install shelves in desired position front glass must be open and rear doors removed.
Remove doors by lifting upwards and then out of bottom track one at a time. Put doors in a safe location. Lift front glass upwards till fully open.
Where shelf height is desired install the shelf support in shelf standard slot (see drawing)
Install shelves on rear shelf support as shown. Curved part of shelf must be toward rear of case if not air flow will be blocked. Snap shelf into retainer clip on the shelf support, this keeps shelf from moving (see drawing)
After installing all shelves close front glass and reinstall doors.