SHELF PLACEMENT:
The shelves can be installed slanted or straight. To make the shelf slanted do the following; a. Shelf needs to be removed from shelf support.
b. Shelf support needs to be held at each end.
c. Shelf support needs to be lifted at the back till bracket can inserted into shelf standard slots. Refer to drawing of pages 5.
ADJUSTING SHELF LEVEL
Shelves can be sdjusted up or down. To move shelves do the following; a. Lights must be turned off.
b. Grasp plug for light cord and unplug.
c. Shelves must be removed from shelf support. d. Hold onto each end of shelf support.
e. Shelf support needs to be moved up until it can removed from shelf standard. f. Shelf can be repositioned in increments of two inches.
REPLACEMENT OF LIGHT
When replacing lights use same model of light installed in Bakery Case. Using wrong wattage can cause ballast to burn out or light not work.
To remove light there is two lamp holders one at each end of light. One has a spring in socket. Push light toward spring loaded lamp holder till other end of light pops out of other lamp holder.
Remove light from lamp shield and insert new light into lamp shield. Reinsert into lamp holders. Never install lamp without shield.