AXIS Q1635 Network Camera
Install the Hardware
NOTICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network cable (STP) may be appropriate or required. Any network cables that are routed outdoors or in demanding electrical environments shall be shielded (STP) and intended for their specific use.
1.Optionally connect external input/output devices, such as alarm devices. See on page 15 for information on the terminal connector pins.
2.Optionally connect an active speaker and/or external microphone.
3.Connect the camera to the network using a shielded network cable.
4.Connect power, using one of the methods listed below:
-PoE (Power over Ethernet). PoE is automatically detected when the network cable is connected.
-Connect an external power adapter to the power connector block. See Connectors and Buttons on page 13.
5.Check that the indicator LEDs indicate the correct conditions. See the table on page 12 for more details. Note that the Status LED can be configured to be unlit during normal operation.
6.Optionally insert a microSD card (not included) into the SD card slot.
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected. To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address, set the password and access the video stream. This information is also available from the support pages on www.axis.com/techsup/
Adjust Focus
To adjust the zoom and focus follow these instructions:
Note
•Set focus as precisely as possible with the focus ring or Focus Assistant before starting automatic fine tuning. Using the focus ring normally gives the best result.
•The iris should always be opened to its maximum while focusing. This gives the smallest depth of field and thus the best conditions for correct focusing.
19
