Sub-Zero IM15/S manual High-temperature Painted brass, Porcelain-coated, Cast iron, Chrome-plated

Page 12

W O L F MULTI-FUNCTION COOKTOP U S E & C A R E

CARE R E C O M M E N DAT I O N S

C O M P O N E N T C A R E R E C O M M E N DAT I O N

S I G N AT U R E P O L I S H

Signature Polish is available from Signature Limited Laboratory,

P. O. Box 13436, Dayton, Ohio 45413-0436, or call 877-376-5474 (toll free).

Exterior Surface Stainless steel

Burner Pan Stainless steel

Although stainless steel is resistant to most stains, it is not totally impervious to damage. Salt and some cooking liquids may pit and stain the surface. Always remove these spills immediately.

For the classic stainless steel exterior finish, use a soft, nonabrasive stainless steel cleaner like Signature Polish (see side note) and apply with a soft, lint-free cloth. To bring out the natural luster, lightly wipe the surface with a water-dampened microfiber cloth, followed with a dry microfiber cloth. All work should follow the grain direction of the finish. Best results are obtained by keeping the cloth in continuous contact with the metal.

Hard water stains: Use white vinegar and water.

Do not use abrasive cleaners (e.g., Scotch-Brite or Soft Scrub); they will permanently scratch the surface. Do not use steel wool pads.

Burner Base

Cool first. Wash in warm water and liquid detergent or mild abrasive

and Head

cleaners.

High-temperature

 

painted brass

 

 

 

Burner Grate

Remove from cooktop and place on a flat surface near the sink.

Porcelain-coated

Nonabrasive cleaners: Hot water and liquid detergent, paste of baking soda

cast iron

and water, plastic pad or sponge.

 

 

Mild abrasive and abrasive cleaners: Use sparingly.

 

 

Control Knob

To remove the knob, slip an edge of a dish towel under the knob; pull the

Chrome-plated

edge together. Using the towel for leverage, lift up; the knob pulls off the

 

valve stem.

 

General care: Wipe the knob with a damp cloth and mild soap and water;

 

rinse and dry. Never soak or use abrasive cleaners; they will scratch the

 

finish and remove the markings.

 

 

Control Panel

Spray cleaners: Use to remove fingerprints and greasy food soils. Spray first

Tempered glass

on a cloth before wiping panel.

 

 

Spark Igniter

Keep dry; never spray water or cleaner directly on the igniter. When cleaning

Ceramic

around the surface burner, be careful that the cloth does not catch on the

 

igniter and damage it.

 

 

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents USE & Care Information N T E N T S Important Note What to do if YOU Smell GAST RO D U C I N G T H E Wolf MULTI-FUNCTION Cooktop Thank YOUEnsure proper installation Keep the igniter clean and dry forWhen cooking, set the burner Always turn panhandles inward soAT not to do Do not use water on grease firesDo not cover the burner and grate Do not heat unopened foodUSE AN Extinguisher only if Flexible gas connector, when used, must not exceed 3 .9 m California PropositionCommonwealth Massachusetts Use only gas shut-off valvesL F MULTI-FUNCTION Cooktop Cooktop F E AT U R E S Ventilation O P T I O N SCooktop Island Hood 42 1067 width L F MULTI-FUNCTION Cooktop U S E & C a R E Surface B U R N E R Cooktop O P E R AT I O N L U M I N AT E D Control Panel Control K N O BCookware S E L E C T I O N Woks STIR-FRYINGCleaning T I P S Wait until surfaces are cool before cleaningUse caution when spraying cleaners Do not spray cleaners on electricalHigh-temperature Painted brass Mild abrasive and abrasive cleaners Use sparinglyPorcelain-coated Cast ironL F Troubleshooting G U I D E Troubleshooting G U I D EFood cooks too slowly when sautéing or stir-frying Food boils out of pan and overflows into burner spill trayL F Service I N F O R M AT I O N F O R E C a L L I N G F O R S E RV I C EFull TWO Year Warranty 7 5 6 2 0 0
Related manuals
Manual 2 pages 53.49 Kb
Top Page Image Contents