Sub-Zero PRO VENTILATION HOODS Heat Sentry F E AT U R E, G H T C O N T Ro L, Filter R E M O VA L

W O L F PRO VENTILATION HOOD U S E & C A R E

R E C E S S E D CONTROLS	HEAT SENTRY F E AT U R E
Controls for Pro ventilation hoods and hood	Heat Sentry feature turns the ventilation hood
liners are recessed under the front edge of the	on when heat is sensed and adjusts the blower
hood. Refer to the illustration below.	speed automatically. The Heat Sentry feature is
	activated when the exhaust temperature from
L I G H T C O N T RO L	the hood reaches 200˚F (95˚C) and deactivated
	when the exhaust temperature decreases to
The left rotary switch operates the halogen	186˚F (85˚C).
lights. There are two settings, HIGH and LOW.	At 200˚F (95˚C) the blower motor will automati-
The LOW setting can be used as a night-light.
	cally adjust to HIGH speed. When the sensor
From the OFF position, turn the switch to the
	cools down to 186˚F (85˚C) it adjusts the blower
desired light setting, left for LOW and right for
	back to the setting that is set on the blower
HIGH light setting.
	control. For example, if blower motor is in LOW
	speed and threshold temperature is reached,
H E AT L A M P C O N T RO L	the blower will increase to HIGH speed.
If your hood is equipped with heat lamps, a
center rotary switch will control the lamps.	FILTER R E M O VA L
Each heat lamp may function independently or
	To remove the stainless steel filters, push each
both lamps may be activated simultaneously
from the single switch. From the OFF position,	filter up at the angle it is placed in, and rotate
simply turn the switch to the right to activate	down. Remove the center filter first. Take out
the right heat lamp or to the left to activate the	the grease cups (if applicable) placed on the
left lamp. When the switch is in the vertical	bottom edge of the hood coinciding with the
position, both heat lamps will be activated.	bottom edge of the filters. Gloves should be
	worn to provide the proper grip. Reinstall using
B L O W E R C O N T RO L	the reverse procedure as shown in the illustra-
	tion below. Outer filters may need to be pushed
The right rotary switch that operates the	over while the center filter is reinstalled.
blower is variable, allowing infinite control of	IMPORTANT NOTE: DO NOT operate the
the blower speed. Rotate the switch fully
	ventilation hood without the filters. This may
counterclockwise to turn the blower off.
	cause damage to the blower or other internal
	components of the hood.

		Blower
	Heat Lamps	Control
Halogen	Control
Lights Control

Recessed controls

	Spring
	Filter
Grease Cup	SIDE VIEW

Filter reinstallation

11