Traulsen VPS72J, VPS66J, VPS54J owner manual III. Installation cont’d

III. INSTALLATION (cont’d)

III. c - PACKAGING (cont’d):

then slide the pallet out from under it. DO NOT LAY THE UNIT ON ITS BACK, FRONT OR SIDE.

NOTE: The front work surface of all Jumbo Rail models can be removed if necessary to facilitate transport through narrow doorways. See section VII.e for details.

III.d - INSTALLING SUPPORTS:

Casters are supplied standard with all VPS models. These are shipped from the factory packed inside a cardboard box, contained within the unit.

WARNING: THE CABINET MUST BE SUPPORTED ON BLOCKS AND STABLE BEFORE INSTALLING CASTERS OR LEGS.

Raise and block the unit a minimum of 9” from the floor. Slide the casters into the two channels under the front and back of the cabinet. Casters can be positioned anywhere along the unit’s entire length to avoid floor obstructions such as drains and outlet boxes. Secure all casters in place by tightening the two bolts located at the base of each caster assembly (see figure 3).

III.e - INSTALLING THE OPTIONAL TICKET RAIL: Supplied standard with jumbo rail models only. Use of the ticket rail is optional and not required. Insert the vertical legs of the ticket rail into the two receptacles located on the rear of the cabinet (see figure 5).

Fig. 5

Ticket Rail Bracket

III.f - OPTIONAL LCD THERMOMETER:

Activate the optional LCD thermometer (if necessary) by removing the paper insulator from the battery contacts. One AA size battery is included. Open or remove the louvered door to access the back of the thermometer.

Fig. 3

NOTE: Casters or legs must be installed towards the four corners of the unit as well as under the compressor compartment for proper support.

Optional legs are installed in the same manner as casters (see figure 4).

III.g – INSTALLING THE SHELVES:

Shelves are shipped in the bottom of the unit. Remove the packaging from the shelves and place them on the pins provided.

III.h – INSTALLING OPTIONAL OVERSHELVES: Optional overshelves are installed in the same manner as with the ticket rail. Insert the vertical legs of the overshelf into the two receptacles located on the rear of the cabinet (see figure 6).

Fig. 4

Fig. 6

Overshelf Bracket

Optional Legs

Use a pallet jack or forklift to prevent damage when moving a unit on legs.

-3-