To replace:
1.Be sure the hinge arms are in the open position. Be careful if pulling the hinges open by hand. Hinges may snap back against the oven frame and could pinch fingers.
2.Hold the door at the sides near the top. Insert hinge arms into slots at the bottom of the door. Insert arms evenly, as far as they will go.
3.lf the door is not in line with the oven frame, remove it and repeat the above steps.
4.Replace the screws on the oven door.
Removing the oven bottom
The panel in the oven bottom can be removed for cleaning or for lighting the burner pilot (see “Lighting standing pilots” on page 11).
To remove:
1.Remove oven racks.
2.Remove the two
3.Place fingers in slots in bottom panel and lift rear of panel up and back until lip at the front of panel is clear of front frame of oven cavity.
4.Lift bottom up and out.
To replace:
1.Place oven bottom panel in oven with the back raised about 6 inches or until you can insert the
2.Push back of oven bottom panel down fully into place on metal flanges on rear wall and insert the
20