Whirlpool SF310BEG warranty Setting the Clock, Display/clock

USING YOUR RANGE

THE ELECTRONIC TIME-OF-DAY (TOD) CLOCK/TIMER

Electronic display

Clock pad (p. 10)

CLOCK

Increase pad

(p. 10, 11)

Oven TIMER

timer pad (p. 11)

TIMER

Decrease pad

(p. 10, 11)

Display/clock

•When you first plug in the range, the display flashes time-of-day. If, after you set the clock (see “Setting the clock” section), the display flashes, your electricity was off for a while. Reset the clock.

•When showing the time of day, the display will show the hour and minutes.

•When you are using the timer, the display will show seconds for time less than 1 minute, minutes for time less than 1 hour, and hours and minutes for time over 1 hour. The timer indicator will be lit when in the timer mode.

SETTING THE CLOCK

1. Press CLOCK. The colon flashes during	PRESS	YOU SEE
clock programming.

2. Set the time.	PRESS	YOU SEE
Press the “up” (▲) or “down” (▼) pad(s) until
the correct time shows on the display.
NOTE: Press a pad briefly to change time by a
small amount. Press and hold a pad to change
time by 10 minute increments.

3. Press CLOCK again to start the clock. The	PRESS	YOU SEE
colon stops flashing when the clock is active.

10