Whirlpool RJE-390P, RJE-395P specs

Hold surface unit level when replacing.

Prop up the top with support rod.

Pull to stop. Lift; pull again.

Replacinn reflector bowls and surface units:

1Be sire the surface unit controls are on “OFF”

Put the reflector bowls back into their places. Make sure you can see the plug-ins (receptacles) for the surface units through the square hole in the side of each bowl and trim ring.

Hold the surface unit level with the prongs (terminals) pointing at the plug-in.

With the prongs started in the plug-in. start pushing in on the surface unit. At the same time. lift a llttle on the side of the surface unit that’s by the plug-in.

Make sure the surface-unit prongs are pushed into the plug-in as far as they will go. The surface unit will fit into the reflector bowl and be level when everything has been done right.

Cleaning under the cooktop:

To clean the area under the cooktop. lift the front of the cooktop at the center. Raise the swing-up rod to hold it. (Be sure the tip of the rod is in the notch in the cooktop.) Use warm soapy water and a sponge or cloth. Scouring powders or any other abrasive cleaner may harm porcelain enamel finishes and can scratch chrome.

Be careful not to raise the cooktop so high that it touches the control console. And don’t drop it. Dropping the cooktop can chip or crack a hard porcelain finish. or damage side panels and surface units.

Removing the storage drawer:

The drawer below your oven is meant to store pots and pans.

Never keep anything in there that will burn or melt.

You may want to remove the drawer for cleaning under the range. Pull it straight out until it stops. Lift the front and pull some more to get it over the stop Now slide it out until it stops again. Lift the drawer away from the range until it slips out of the guides.

To put It back. fit the side rails at the back of the drawer into both guides on the range Push it closed while lifting the front to get past the stops.