A RADIO OPERATION
1 Press RADIO BAND * repeatedly to select the desired band.
FM AM
The power is turned on and the previously tuned station is received.
*or BAND on the remote control (applicable when the AC cord is connected)
2 Press f, g (TUNING -, +) to select a station.
During FM stereo reception, 
is displayed.
After listening, press POWER 6 STANDBY/ON to turn the power off.
For better reception
FM | AM |
REPEAT/MODE/SLEEP *
- If an FM stereo broadcast contains noise, press the
button so that is displayed.
Noise is reduced, although reception is monaural. To restore stereo reception, press the button again.
- If a
* or MODE on the remote control
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/ step. If you use the unit in an area where the frequency allocation system is 9 kHz/step, change the interval as follows.
1Press RADIO BAND.
2Press POWER 6 STANDBY/ON while pressing
RADIO BAND.
When the AM tuning interval is changed, the preset stations are cleared.
Extend the rod antenna | The antenna is inside the |
and orient it for the best | unit. Position the unit for |
reception. | the best reception. |
For quick tuning (Auto Search)
Keep f, g pressed until the tuner starts searching for a station. When a station is tuned to, the search stops.
If the broadcast signal is weak, it does not stop. To stop the search manually, press f or g.
To listen with the headphones
Connect headphones with a stereo mini plug to the
\PHONES jack on the rear of the unit.
6ENGLISH
NOTE
If the unit picks up noise from other electrical appliances nearby, like a TV or fluorescent lights, move the unit.