Cornelius IDC 2XX manual Replenishing CO2 Supply, Cleaning Dispensing Valve

IDC Operator’s Manual

Replenishing CO2 Supply

NOTE: When indicator on the 1800-psi gage is in the shaded (“change CO2 cylinder”) portion of the dial, CO2 cylinder is almost empty and should be changed.

1.Fully close (clockwise) the CO2 cylinder valve.

2.Slowly loosen the CO2 regulator assembly coupling nut allowing CO2 pressure to escape, then remove the regulator assembly from the empty CO2 cylinder.

3.Unfasten safety chain and remove the empty CO2 cylinder.

WARNING: To avoid personnel injury and/or property damage, always secure the CO2 cylinder with a safety chain to prevent it from falling over. Should the valve become accidently damaged or broken off, a CO2 regulator can cause serious personnel injury.

4.Position the full CO2 cylinder and secure with a safety chain.

5.Make sure gasket is in place inside the CO2 regulator assembly coupling nut, then install the regulator assembly on the CO2 cylinder.

6.Open (counterclockwise) the CO2 cylinder valve slightly to allow the lines to slowly fill with gas, then open the valve fully to back-seat the valve (back-seating the valve prevents gas leakage around the valve shaft).

7.Check CO2 connections for leaks. Tighten any loose connections.

Cleaning Dispensing Valve

1.Remove nozzle assembly (contains Inner Nozzle) from dispensing valve. Separate the inner nozzle from the nozzle and wash the two parts in warm water.

2.Remove the bottom plate by releasing the two snap-fit clips. Remove the lever from the bottom plate and wash the bottom plate and the lever in warm water.

3.Reassemble the lever into the bottom plate and return the bottom plate to the valve. Be sure the rear tabs are properly secured.

4.Return the inner nozzle to the nozzle and replace the assembly to the valve.

	BOTTOM
SNAP FIT CLIP	PLATE P/N
	1903
	SNAP FIT
	CLIP

SNAP FIT		REAR
CLIP
	O	TAB

FSNAP FIT

FCLIP

INNER

NOZZLE

NOZZLE

© 2005-2006, IMI Cornelius Inc. - 5 - Publication Number: 621057403OPR