Electrolux - Gibson 241512200A warranty Gibson TM * Ice and Water Filter some models

Page 14
14
• Rated Capacity - 400 gallons
• Rated service flow - .5 GPM
• Maximum Rated Pressure - 100 PSI
• Maximum Operating Temp. - 100° F
IMPORTANT: Resetting The Filter Status Light (some models)
After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.
On models without a Filter Status reset button, there is a set of Reminder Stickers included in the envelope that the Use & Care Manual came in. Choose a dated sticker that indicates 6 - 9 months (depending on your water quality and usage) from the date of installation. Place the sticker on the front of the filter cup to remind you when it is time to change the filter.
Order new filter cartridges through the dealer where you bought the refrigerator, or contact the Consumer Assistance Center at 1-800-944-9044, or go to our web site at www.frigidaire.com. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the RG-100Gibson™* replacement cartridge.
The Gibson™ * NGRG-2000
Ice and Water Filter System with the RG-100 cartridge is tested and certified by NSF
International, the nationally recognized and respected, not for profit, certification organization for public health safety. The Gibson™* system is tested and certified to ANSI/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.
Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed).
To change filter:
It is not necessary to turn the water supply off to change the filter.
1. Open freezer door and leave open until filter change is complete.
2. Set ice maker wire signal arm to the OFF (up) position (See illustration on page 12).
3. Hold filter cup firmly, and unscrew towards left (Some water could
leak out as you remove cup. This is normal.). Filter cartridge should come down with cup. If cartridge remains in housing, pull down gently, while twisting filter back and forth.
4. Rinse out cup under running water.
5. The large o-ring that seals the filter system sets in the o-ring groove down inside the cup. Should the o-ring fall out during filter cartridge replacement, simply place it back in the groove prior to screwing the cup back in place. If the o-ring becomes damaged, you will need to order one from the Consumer Assistance Center.
6. Discard old filter cartridge.
7. Remove new filter cartridge from packaging and place in cup. The end with the small o-ring should be up, out of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is completely tightened with PureSource™ logo facing outward. Do Not
Tighten Past Stop.
9. Set ice maker wire signal arm to the ON (down) position.
10. Check for leaks. Open refrigerator door. Wipe any water droplets from the filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and reinsert the filter cartridge. Check placement of large O-ring. Reinstall filter cup, making certain it is tightened completely.
11. To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in the water tank.
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section
to properly fill the system with water. Changing the Filter:

Automatic Ice and Water Dispenser

Gibson TM * Ice and Water Filter (some models)

NOTE: If you purchased a refrigerator with a Gibson TM * Ice and Water filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment.

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Us e & Care Manual Welcome & Congratulations Please Read and Save These InstructionsChild Safety Important Safety InstructionsFor Your Safety Proper Disposal of Your Refrigerator or FreezerInstallation Before Installing The Water Supply Line, You Will Need To Connect Water Supply Line To Ice Maker Inlet ValveTo Remove Refrigerator Door Door Removal InstructionsDoor Removal Instructions To Remove Freezer DoorFeatures At a Glance Temperatures gradually move the knob in small Temperature ControlsRefrigerator & Freezer Controls Temperature Adjustment Increments, allowing the temperature to stabilizeLooking Inside Cantilever Shelf AdjustmentTo adjust cantilever shelves TIP-UP Shelf Some ModelsCrispers Some Models Adjustable Door BinsHumidity Control Some Models Deli Drawer Some ModelsAutomatic Ice and Water Dispenser How the Ice Dispenser Works ICE and Water Dispenser FeaturesHow the Water Dispenser Works ICE Dispenser TipsCleaning the ICE Dispenser Remove and empty the ice storage bin ifGibson TM * Ice and Water Filter some models Energy Saving Ideas Food Storage & Energy Saving IdeasFood Storage Ideas Normal Operating Sounds & Sights Care & Cleaning Replacing Light Bulbs Warranty Information Gibson Refrigerator Platinum Advantage WarrantyRefrigerator Warranty Canada Running of Refrigerator Temperatures are TOO ColdBefore You Call OPENING/CLOSING of DOORS/DRAWERSWATER/MOISTURE/FROST Outside Refrigerator Temperatures are TOO WarmWATER/MOISTURE/FROST Inside Refrigerator Automatic ICE MakerICE Dispenser WarmOPENING/CLOSING of DOORS/DRAWERS Water DispenserOdors in Refrigerator Light Bulb is not on

241512200A specifications

Electrolux has been a trusted name in home appliances for decades, and the Gibson 241512200A is a prime example of their commitment to quality and innovation. This model combines versatility with advanced technology to elevate the cooking experience, making it an ideal choice for modern kitchens.

One of the standout features of the Gibson 241512200A is its spacious design. With a generous interior capacity, this appliance can accommodate large dishes, making it particularly suitable for families or those who enjoy entertaining. The thoughtful layout allows for easy organization and access, so users can find their cooking essentials without hassle.

The Gibson 241512200A utilizes advanced cooking technologies that enhance its performance. It features precise temperature control, which ensures that food cooks evenly and to perfection. This is especially important for baking and roasting, where consistent heat is critical. Additionally, the appliance incorporates innovative heating elements that contribute to faster cooking times, saving users valuable time in the kitchen.

Another remarkable technology integrated into the Gibson 241512200A is its user-friendly interface. The digital control panel is intuitive, allowing users to adjust settings with the touch of a button. This feature is complemented by a variety of cooking presets, which simplify meal preparation by automatically setting optimal cooking times and temperatures for different dishes.

Safety is also a major consideration in the design of the Gibson 241512200A. The appliance comes equipped with features such as an automatic shut-off function that provides peace of mind, especially for busy households. The cool-touch exterior ensures that the surface remains safe to touch during and after cooking, minimizing the risk of burns.

In terms of energy efficiency, the Gibson 241512200A excels as well. It is designed to consume minimal energy without compromising performance, making it an environmentally friendly option for consumers looking to reduce their carbon footprint.

In conclusion, the Electrolux Gibson 241512200A stands out due to its combination of spacious design, advanced cooking technologies, user-friendly interface, safety features, and energy efficiency. This appliance truly encapsulates what a modern kitchen needs, making it an essential tool for both novice cooks and seasoned chefs alike. Its blend of functionality and innovation ensures that users can enjoy a seamless cooking experience, resulting in delicious meals for family and friends.
Top Page Image Contents