8. Assembly instructions
8.1 Important notes
Please observe the safety notes and the important notes (Chapter 1).
The installing technician is responsible for perfect functioning of the appliance at its installation location. He must explain the operating principle to the user with reference to the operating instructions and must show how to switch of the electricity and gas whenever required.
Caution:
Before connecting the appliance, please check whether the local connection conditions such as the gas type, gas pressure and mains voltage and the appliance settings are correct. Refer to the adhesive label on the gas connection or the rating plate for the necessary information. This gas hob conforms to the categories that are specified on the rating plate. The rating plate can be found on the appliance and additionally on the enclosed addendum sheet. By replacing nozzles, it is possible to set the appliance to any gas listed on the rating plate. If the data should not agree, the appliance must be set to the required gas type and the available pressure.
As this gas hob is not intended for connection to an exhaust gas system, pay attention to the applicable installation conditions.
Note on ventilation:
To ensure good combustion, the room in which this appliance is installed must have a minimum volume of 10 m3 and a door that opens out to outdoors or a window that can be opened.
Note: the appliance must not be combined with hob ventilators.
The appliance may be installed in kitchen combinations made of wood or similar combustible materials without taking additional measures. The rear wall must consist of
A minimum distance of 150 mm (6”) from heat- sensitive items of furnishing or contact surfaces (cupboard side panel) must be observed.
The hob conforms to appliance class 3 and must be installed in the worktop as shown in the installation sketch.
The distance between the suspended cupboard and the worktop must be at least 600 mm (24”).
Attention must be paid to the manufacturer's specified safety clearance when a vapour extractor is installed.
Wall trims must be
After unpacking, check the appliance for any transportation damage and report this immediately to the transportation company.
Technical modifications reserved.
15