Gaggenau Wok manual Nozzle replacement

Page 17

8.3 Nozzle replacement

Fig. 10

1

Fig. 11

2

3

Fig. 12

Changing over to a different gas type

Only authorised specialists are permitted to change over to a different gas type. The nozzles needed for the gas type to be set are available as a conversion kit. Please specify the appliance type and the required gas type.

Disconnect the appliance from the power supply.

Remove the pot support, the burner ring, the burner cover and the burner head.

If the appliance is connected rigidly to a gas main, it must be disconnected from the gas network. If it is connected via a gas safety hose, the appliance only needs to be pushed out of its mount from below and taken out of the worktop.

Undo the securing nut (SW 11) of the thermocouple and the two securing screws that become visible under the detached burner head (Fig. 10).

Remove the hob.

Pull off the control knob. After undoing the securing screws (1) on the left and right (Fig. 11), you can remove the control panel by lifting (2) and pushing (3) it out of the latch (Fig. 12).

17

Image 17
Contents VG 231 CA For Your SafetyFor Your Safety CAN/CSA Z240 MH CAN/CSA Z240 RV Preface Operating for the first time For your safetyImportant notes About use Structure Special accessoriesStructure and operating principle Off Operating principleLevel Low LevelOperation Cleaning and care General Remedying slight malfunctions yourself MaintenanceTechnical data / Table Cooking in the wok Wok and accessoriesPractical tips Recipes Important notes Assembly instructionsConnecting the appliance Nozzle replacement Page Page Installing the appliance Gas cooker Operating and assembly instructions