Wood Drawer Fronts
The full extension drawer fronts on the beverage cooler are unfinished maple wood. During use, oil from hands may accumulate and stain the wood.
•The drawer fronts may be stained and sealed to match adjacent cabinetry. The tinted glass will make the stained wood appear darker. A true color match can be seen only when the door is opened.
•Apply the stain and sealer according to the manufacturer’s instructions. To avoid unpleasant odor, keep the door open to ventilate and allow the stain/sealer to dry completely before using the product.
NOTE:
Natural wood may vary slightly in grain and color.
Loading Tips and Suggestions
WARNING:
Do not allow children to climb, stand or hang on the beverage cooler shelves or full extension drawers. They could seriously injure themselves and possibly cause damage to the beverage cooler.
NOTE:
This unit is for storing beverages only and not intended for the storage of perishable foods.
The bottom two full extension drawers hold six bottles each and are loaded with necks facing the rear. Tall bottles should not be loaded on the bottom drawer because they may prevent the door from closing.
The top five full extension drawers (EWC model only) each hold eight bottles, two deep with the necks alternating front to back or nine bottles, alternating with necks pointing inward.
•The bottles on the top full extension drawer, directly under the light, will be exposed to a slightly higher temperature when the light is on. Position your wines accordingly and remember to turn off the light when it is no longer needed.
•Keep wines that you plan to use for everyday drinking and entertaining on the front half of the full extension drawers where labels are completely visible. Place wines for aging or longer term storage in the rear.
Care and Cleaning
WARNING:
Unplug the appliance before cleaning.
Cabinet
The exterior surfaces can be washed with mild soap and water. Rinse thoroughly with clear water. Never use abrasive scouring powders.
Glass Door
Use a glass cleaner or mild soap and water and a soft cloth to clean the glass door. Do not use any abrasive powders.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water, a baking soda solution or a mild scouring powder. Rinse well.
After cleaning the door gasket, apply a thin layer of paraffin wax or petroleum jelly to the door gasket at the hinge side. This helps keep the gasket from sticking and bending out of shape.
Cleaning the Inside
Turn the appliance OFF or unplug the unit before cleaning. Use a slightly damp cloth or sponge when cleaning around switches, lights or controls.
Use warm water and baking soda solution— about a tablespoon (15 ml) of baking soda to a quart (1 liter) of water. This both cleans and neutralizes odors. Thoroughly rinse and wipe dry.
Other parts of the
Avoid cleaning cold glass shelves with hot water because the extreme temperature difference may cause them to break. Handle glass shelves carefully. Rough handling of tempered glass can cause it to shatter.
Drain Hole
Periodically check the drain hole and channel for any debris. If the drain is blocked, condensation will not drain properly.
To check and clean the drain hole, remove the bottom two glass shelves. Sweep a damp cloth along the channel in the back of the beverage cooler. Use a finger to sweep away any debris from the drain hole.
Drain hole
Light Bulb Replacement
Unplug the beverage cooler before replacing the light bulb.
To remove the light shield, push in the tab on the left side of the shield and lower it. Replace with a 15 watt appliance bulb.
In the Event of a Power Failure
If the power fails, open the door as infrequently as possible to maintain the temperature.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
3