Daewoo ERF-36.M, ERF-41.M, ERF-39.M, ERF-33.M, ERF-38.M Disconnection, Protecting the Environment

English

-Should the mains lead ever require a replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord obtained from the manufacturer.

-After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost a replacement cover must be obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the plug or the colour that is embossed in words in the base of the plug recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.

-Only 13 amp. replacement fuses which are ASTA approved to BS 1362 should be fitted.

4.Check the rating plate (8) for voltage information.

5.The socket should be easily accessible and not directly behind the appliance.

6.Electrical connections must be made in accordance with local regulations. The appliance must be earthed as described by law (connected through a properly earthed plug and socket). The manufacturer rejects all liability for injury to persons and animals or damage to property resulting from failure to comply with this requirement.

7.A 10A fuse or one of a higher value must be used in the socket circuit.

8.If the appliance plug and the wall socket are incompatible, the socket must be replaced by a qualified electrician.

9.If the supply cord is damaged, it must be replaced by the manufacturer or his service agent or a similarly qualified person in order to avoid hazard.

10.Do not use extension leads or multiple adapters, etc.

11.In some countries a plug has to be fitted. Make sure that the installation and electrical connections are performed by a qualified technician in compliance with the manufacturer’s instructions and current local safety regulations. The wires in the mains lead are coloured in accordance with the following code:

-green/yellow = earth

-blue = neutral

-brown = live.

DISCONNECTION

Note: does not apply in the UK.

Electrical disconnection: remove the plug from the mains, or (if applicable) disconnect the two-pole circuit breaker upstream from the socket.

PROTECTING THE ENVIRONMENT

-The packaging may be completely recycled, as confirmed by the recycling symbol; follow local disposal regulations.

-The appliance is manufactured from reusable materials.

-When you decide to scrap this product, please check the cable to be disconnected from the mains. Then cut off the cable and dispose of the product according to local waste disposal laws.

-This product is free of CFC’s (cooling circuit contains R134a or R-600a). Check the compressor label on the rear of the appliance or the rating label inside the fridge to see which refrigerant is used for your refrigerator.

IMPORTANT

1.Although this product was carefully checked before packing, please check the product:

-for damage;

-for correct closing of the doors.

Complaints must be reported to your retailer within 24 hours of delivery.

2.Installation instructions (7 drawings below).

3.Keep potentially hazardous packing materials (plastic bags, etc.) out of reach of children to prevent the risk of trapping

and suffocation.

Check for damages and correct	Not in the vicinity of a heat source.
closing of the doors.

Keep room dry and well ventilated.	Keep more than 5cm distance space
	at the top for ventilation.

Clean interior with a damp cloth.	Best room temperature range -
	+16°C to +32°C.

Wait 2 hours before connecting to the mains.

4