Danby DWC166BLSRH owner manual Tools You Will Need, Electrical Requirements, Door Swing

Instrucciones de Operación

Installation Instructions - Integrated Application

Almacenamiento de Vinos

¡IMPORTANTE!

• La capacidad máxima* de

la DWC166BLSRH es de

Para aprovechar la capacidad máxima de 166 botellas, éstas deben colocarse alternadamente en las trece (13) repisas superi- ores como se muestra en la Fig. C. Así se podrán almacenar once (11) botellas de 750 ml en cada una de las trece (13) repisas.

Fig. C

Tools You Will Need

WA R N I N G !

While performing the installations described in this section; gloves, safety glasses or goggles should be worn.

Safety Glasses	Gloves	Level
		Flashlight

Carpenter’s

Square

Drill & Hole Saw set	Measuring
	Tape

166 botellas de vino (de

750ml).

• Guarde el vino en botellas

cerradas únicamente.

*Cuando se guarden de acuerdo con las instrucciones.

Cada una de las dos (2) repisas inferiores tiene capacidad para siete (7) botellas de acuerdo a la

Fig. D.

La repisa superior tiene capaci- dad para veinte (20) botellas de vino cuando se colocan once

(11)botellas alternadas de acuerdo a la Fig. C; y luego otras nueve (9) botellas alternadas encima y entre las once (11) botellas de abajo, como se muestra en la Fig. E.

Fig. D

Preparing the Enclosure

Electrical Requirements

The appliance must be con- nected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.

• It is recommended that you

do not install the wine cooler

into a corner (i.e. directly

beside a wall). This is to allow

the door to have a greater than

90° opening swing. A limited

door swing will prevent the

shelves from sliding out as

intended, and may lead to

damaging the door gasket.

• The rough cabinet opening

must be on a level floor area

and at least 26 7/8” (68.26cm)

deep* by 23 3/4” (60.33cm)

wide. The opening should also

•The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig. B).

Important: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirement for the installation may be affected.

• If the electrical outlet is locat-

ed inside the adjacent cabi-

netry, cut a 11/2” (3.81cm)

diameter hole to admit the

Fig. E

IMPORTANT!

have a height of at least 69 3/4”

(177.17cm).

power cord.

Fig. B

Door Swing

Do not include the door within the enclosure; leave it outside of the enclosure to prevent the door swing from being obstructed.

	69 3/4”/	}
177.17cm
}	26 7/8”*/
	68.26cm
Electrical			Cabinets
Access: 2” /			must be
3.81cm			square
}			and
			plumb.
	}
	233/4”/ 60.33cm

*The listed depth requirement for the installation is assuming that the electrical outlet is located in the adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.

32 5