QSC Audio CM16a manual Introduction- Physical Characteristics & Layout

Page 6

Section 1: Introduction- Physical Characteristics & Layout

PHYSICAL CHARACTERISTICS

The CM16a is one rack space high (1RU) and has an internal, univeral 100-240V AC power supply. The chassis is 37.7 cm (14.84”) deep. The width of the chassis, less rack ears, is 43.7 cm (17.20”). For detailed mounting dimensions, refer to the Section 4: Specifications- Dimensions (page 32). The weight of the CM16a is approximately 5 kilograms (11 pounds).

FRONT PANEL (numbers correspond to reference locations shown in illustration above)

1-

POWER switch

2-

Cooling air exhaust vents (intake vents are located on left side of chassis as viewed from the front)

3-

POWER on indicator

4-

DIAGNOSTIC indicator

5-

RCV, XMT and LINK STATUS network status indicators

6-

PORT A - PORT H connection indicators

7-

Access hole for the BYPASS switch (this is not labeled on the panel)

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents
CM16a Amplifier Network Monitor ¨ Warning ¨ Table of Contents CM16a Amplifier Network Monitor Federal Communications Commission FCC Information Introduction- Overview Series are not supported by the CM16aIntroduction- Physical Characteristics & Layout Physical CharacteristicsIntroduction- Physical Layout Diagram RS-232 port for network and firmware utilitiesIntroduction- List of Functions & Features Functional LISTING, Block Diagram & Detailed DescriptionsIntroduction- Block Diagram part Introduction- Block Diagram part Introduction- Detailed Description of Functions Introduction- Detailed Description of Functions Amplifier Monitoring FunctionsRS-232 Port Functions Introduction- Network Description Introduction- Sample Network Topologies Introduction- Sample Network Topologies Unpacking Installation- Basics and MountingWhat is Included in the Carton Location ConsiderationsInstallation- Mounting and AC Power Connecting AC PowerInstallation- Connections Connecting Audio InputsConnecting the RLY OUT Connecting page InputConnecting the RLY/TRG Connecting the Monitor Chain IN/OUTConnecting to the RS-232 Port Connecting to 2-CHANNEL AmplifiersConnecting to 4-CHANNEL Amplifiers Installation- Rear Panel Detail Operation- LED Indicators Port Connected LED’sOperation- General Information & Presets START-UP Behavior and Preset OperatingOperation- Recalling Presets Using RLY/TRG Most up-to-date informationOperation- Bypass Modes and Switch Location HOW to put the CM16a into Bypass Mode #1HOW to put the CM16a into Bypass Mode #2 RS-232 Communications Procedure Operation- Serial Port I/O InterfaceXon/Xoff IP Address Assignment Only Required for Attaching to Existing NetworksOperation- Telnet Access This is the basic procedure for opening a Telnet sessionOperation- Fuse Replacement Fuse ReplacementSpecifications- Dimensions Specifications Input Signal ProcessingPower amplifier output processing Power amplifier management Control room foldback monitoringContact closure inputs and outputs RS232 Port GeneralARCHITECT’S and ENGINEER’S Specifications Appendix- Ethernet Cable Pinouts Ethernet CablingAppendix- DataPort Pin-out & Connector P-N’s Pin Signal DescriptionRS-232 Pinout How to Contact QSC Audio Products
Related manuals
Manual 40 pages 2.28 Kb
Top Page Image Contents