Dometic RM2451, RM2551, RM2351 installation manual Refrigerator Removal, Snap, With screws

MOUNTING INSTRUCTIONS

RM2351-2354

We recommend to mount the panel on the door before the refrigerator is installed in the enclosure.

To mount the panel, follow these steps:

1. Slide the panel from the bottom of the door into the grooves on the vertical edges of the door .

2.Push the panel upwards.

3.Put the two plastic panel stops (from the parts bag) in the two holes at the lower door frame.

4.Put the decoration strip across the door and fasten it with three screws (from the parts bag).

RM2451-2454-2551-2554-2652-2662- 2663-2852- 2862 & NDR1062

Snap in

To mount the panel, follow these steps:

1.	Open the door 90 degrees.
2.	On new refrigerators,	1

the decoration strip are taped inside the door; if installed on the door, remove the door decora- tion strip (2) by gently pushing the four tabs away with a flat blade screwdriver (1).

3.	Insert the vertical edges
	into the grooves of the
	door frame (3).
4.	Push the panel down-

2

2

With screws

To mount the panel, follow these steps:

1. Open the door 90 de-

grees.

2.	On new refrigerators,
	the decoration strip is
	taped inside the door; if
	installed on the door, re-
	move the door decoration
	strip (2) by removing its
	three screws (1).
3.	Insert the vertical edges

1	1	1
	2

wards so that the lower

horizontal edge of the

panel (4) is fitted into

the bottom grove (5).

5. Snap in the decoration

strip (2).

into the grooves of the

door frame (3).

4. Push the panel down-

wards so that the lower

horizontal edge of the

panel (4) is fitted into the

bottom grove (5).

1 1 1

3

3

5. Put the decoration strip

across the door so that

the gap is covered. Se-

cure the decoration strip

with the three screws

removed in step 2.

4

5

REFRIGERATOR REMOVAL

Before removing the refrigerator:

Verify that the AC and DC voltage leads are disconnected.

Shut off the gas supply.

Disconnect the gas supply line at the rear of the refrigerator. Always use a back up wrench when loosening and tighten- ing connections.

To remove the refrigerator, follow these steps:

1. Cap the gas supply line.

2.Loosen the screws anchoring the refrigerator to the enclosure.

3.Slide the refrigerator out of the compartment.

Replacement is the reverse of removal. When reinstalling the refrigerator, make sure the sealing strips are properly posi- tioned. Check all connections for gas leaks.

- 10 -