Whirlpool WFE320M0AS warranty Troubleshooting, OvenLight, Storage Drawer or Warming Drawer on some

STORAGE DRAWER OR WARMING DRAWER (on some

models)

Check that storage drawer or warming drawer is cool and empty before cleaning.

Cleaning Method:

■Mild detergent

OVEN CAVITY

Do not use oven cleaners on models with self-clean.

Food spills should be cleaned when oven cools. At high temperatures, foods react with porcelain and staining, etching, pitting or faint white spots can result.

Cleaning Method:

■See the “Self-Cleaning Cycle” section, if available on your model.

The oven light is a standard 40-watt appliance bulb. Before replacing, make sure the oven and cooktop are cool and the control knobs are in the off position.

To Replace:

1.Unplug range or disconnect power.

OvenLight

2.Turn the glass bulb cover in the back of the oven counterclockwise to remove.

3.Turn bulb counterclockwise to remove from socket.

4.Replace bulb, then bulb cover by turning clockwise.

5.Plug in range or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call.

www.whirlpool.com

Operation

PROBLEM	POSSIBLE CAUSES	SOLUTIONS
Nothing will operate	Power supply cord is unplugged.	Plug into a grounded outlet.
	Household fuse is blown, or a	Replace the fuse or reset the circuit breaker. If the problem
	circuit breaker is tripped.	continues, call an electrician.
	The control displays an F9 or F9	The electrical outlet in the home may be miswired. Contact a
	E0 error code.	qualified electrician to verify the electrical supply.
Cooktop will not operate	The control knob is not set	Push in knob before turning to a setting.
	correctly.
	On ceramic glass models, the	See the control lock keypad feature in the “Feature Guide.”
	oven control lockout is set.
Excessive heat around	Cookware is not the proper size.	Use cookware about the same size as the surface cooking
cookware on cooktop		area, element or surface burner. Cookware should not extend
		more than ¹⁄₂" (1.3 cm) outside the cooking area.
Cooktop cooking results not	Control knob set to incorrect heat	See “Cooktop Use” section.
what expected	level
	Range is not level.	Level the range. See the Installation Instructions.
Cooktop element cycles on	Element cycling due to a	This is normal operation. The element may cycle on and off to
and off on High setting.	temperature limiter	keep the cooktop from overheating.
Oven will not operate	Delay start is set.	See “Cook Time” section.
	Control lock is on.	Press and hold START for 3 seconds to unlock.
	Control is in Demo Mode.	Press and hold START TIME for 10 seconds to exit Demo
		Mode. Demo Mode is used for display models in a showroom.
	Electronic oven control set	See “Electronic Oven Controls” section.
	incorrectly
Oven temperature too high or	Oven temperature needs	See “Oven Temperature Control” in the “Electronic Oven
too low	adjustment.	Controls” section.

Oven indicator lights flash	Power to range is turned on or
	restored.

See “Control Display” in the “Electronic Oven Controls” section. If the indicator lights keep flashing, call for service. See cover for contact information.

13