Whirlpool ED25PM manual Cold Water and Ice Dispenser

Page 8

/

I

Cold Water and Ice Dispenser.. .

FORICE:

Press o sturdy glass against the Ice dispenser bar. (Pressure and tumbling can break a fragile glass.) Remove the glass to stop dispensing.

The first few batches of Ice the Ice maker may have a taste. Throw them away. T from new plumbing and pa

Ice Dispenser Bar

FORCHILLEDWATER:

Press a sturdy glass against the water dispenser bar. [Pressure

can break a fragile glass.) Re-

move the glass to stop

dispensing.

If the dispenser ISnot used reg-

ularly. dispense enough every

weektofreshen thesupply. Allow

2-3 hours for chilling.

The small. heated tray beneath the dispenser is designed to evaporate small spills. There is no drain In this tray. Do not pour water into It.

Ice is dispensed from the ice maker storage bin in the freezer. When the dispenser bar is pressed, a trapdoor opens in a chute between the dispenser and the ice bin. Ice is moved from the bin and falls through the chute. When the dispenser bar is re- leased, a faint buzzing sound may be heard for a few seconds.

Chllled water comes from a tank behind the meat pan. It holds about 50 ounces (1.5 L).

When the refrigerator is first hooked up, press the water dispenser with a glass or a jar until you have drawn and discarded 2 or 3 quarts (1.9 to 2.8 L).

Only air will come out to start with. The water you draw and discard will rinse the tank and pipes.

Allow about 24 hours to chill the first tankful.

PROBLEM

Dispenser won’t work.

ice dispenser won’t work.

ice dlspenser stops working.

Off-taste or odor in ice.

CAUSE

Freezer door open

Ice bin not properly installed. Wrong ice in ice bin.

Ice dispenser bar held in too long.

Ice attracts airborne odors. Old ice.

Water quality.

Foods not properly wrapped.

Ice bin and freezer may need cleaning.

Plumbing to ice maker.

New ice maker.

l

l

l

l

l

l

l

l

l

l

l

l

SOLUTION

Close the freezer door.

Make sure bin is pushed all the way in.

Use only ice crescents from ice maker.

Other shapes won’t dispense properly.

,. , .x., ..,.3 :., :,,,<. ..

Wait about 3 minutes for the dispenser motor to reset.

Large amounts of ice should be taken from

the bin, not through the dispenser.

_,,,-* j pl.r.

Use rapidly or store in covered container. Dump old ice and make new supply.

Water containing minerals [such as sulfur) may require a filter to remove.

Wrap properly. See pages 13 and 14.

Clean freezer and ice bin. See Cleaning Chart on page 11.

Follow installation instructions for proper ice maker water supply hook-up.

The first few loads of ice from a new ice maker may have an off-taste. Dump ice and make new supply.

Image 8
Contents NO-FROST REFRIGERATOR- Freezer Copy your Model and Serial Numbers here Parts and featuresBefore you do anything else Contents Install properly Clean itLevel refrigerator-freezer Remove sales labelsUsing your refrigerator Setting the controlsChanging the control settings Power Saving ControlAdjusting meat pan temperature Adjusting the refrigerator shelvesRemoving the freezer shelf Removing the freezer basket +==-=llRemoving the base grille Removing the crispeq meat pan and coversChanging the light bulbs Cold Water and Ice Dispenser Tips Plan to remove and empty the storage blnSounds you may hear Energy saving tipsPossible Sounds Probable CausesCleaning your refrigerator Cleaning chartStoragechartforfreshand Curedmeat Food storage guideFreezing & Storing Frozen Foods Do not USEFreezing Baked Goods-Wrap baked breads If electricity goes off FoodFood Storage Vacation Short vacationsLong vacations MovingBefore calling for assistance If you need service If you have a problemIf you need FSP replacement parts% If you need assistance?Page Length of Warranty WarrantyWhirlpool Corporation For Full ONE-YEAR