Whirlpool ET14LC Lift the back, Model Em2LK, To remove crisper, To remove cover, To replace cover

Lift the back,

then slide out to the rear and IIR out.

Ralw slgnal arm to stop Ice

Lower slgnal armto starttt

Removlng the crisper and crisper cover

Model	Ell2LK	Model Em2LK:
		To remove crisper:
		1. Slide crisper straight out.

To remove cover:

1.Lift back, then slide to the rear until the front can be lifted.

2.Lift cover up and out.

To replace cover:

1.Slide the front cover tabs into the back of the front supports on the refrigerator walls.

2.Lower back into place.

Model ETl4LC:

To remove crisper:

1.Slide crisper out to the stop.

2.Lift the front.

3.Slide the rest of the way out.

4.Replace in reverse order.

To remove cover:

1.Lift the front, then the back.

2.Pull up and out.

To replace cover:

1.Fit notches on back of cover into back nubs on wall of refrigerator.

2.Lower front into place.

Ice cube tray

If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes ate stored, the smaller they get.

To remove ice:

1.Hold tray at both ends.

2.Twist slightly

Optional automatic ice maker (model ETlPLK)

If you have the automatic ice maker accessory, or if you plan to add one later (Part No. ECKMF-90), there are a few things you will want to know:

l The ON/OFF lever is a wire signal arm. Down.. .for making ice automatically. Up...to shut off the ice maker.

NOTE: Do not turn ice maker on until it is connected to the water supply.

lThe dial or lever on the side of the ice maker changes the size of the cubes.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.

7